home > products > process control > glass plate
Search for:
Glass plate

INTERFLUX®

Glass Plate is used to measure solder wave contact times and parallelism.
Typically it is mounted in a board carrier or finger transport of a wave soldering machine and passed through the whole wave soldering process including fluxer unit and pre heating before passed over the solder wave. Its characteristics make it possible to be stopped right on top of the solder wave for easy monitoring.


The INTERFLUX® Glass Plate has marks every 1cm.

Contact times of the solder wave are calculated by using the wave contact calculator on this page.

IF Glass plate

  
Application

Float the INTERFLUX® density meter in the alcohol based flux in such a way that it floats free without touching the flux holder sides. Allow it to get the flux temperature for 2 minutes.
 
 
1.

read the density value displayed on the density meter.
2.

note the temperature on the build in thermometer.
3. correct the density of the flux when needed with the appropriate flux thinner
   
 
   
   
   

 
Technical specifications

 

 


material
length
max. width
max. temperature

 


high temp. resistant glass
290mm
210mm
750°C - 1500°F

documents  
  technical data sheet

pdf wave contact times table

xls wave contact calculator

 


packaging


Interflux glass plate is sold seperatly
   
   

   
 
 
© 2007-2008 All Rights Reserved by Interflux Electronics